ISOCUBE - Решение для электростатического нанесения водных материалов
Complete solution for electrostatic Airspray applications with water-based materials
- Adjustment of the fan width and the electrostatic effect on the gun
- High transfer efficiency thanks to the wrap around effect limiting the material losses on the booth while reducting VOC emission with water-based paint
- Plug & spray solution that's easy to assemble
- Intuitive settings from the gun or from the controller
- Robust construction that can be transported easily
- Careful selection of parts in contact with the material to ensure perfect compatibility with water-based paints
ISOCUBE Airmix для электростатического нанесения водорастворимых материалов
Наша компания предлагает несколько опций по электростатическому нанесению водорастворимых материалов с использованием того или иного решения ISOCUBE
The nanogun Airspray spraygun must be fitted with our genuine 1.2 spray nozzles to guarantee the best results.
"Tips and Tricks":
To coat tubular shapes and grid parts, we do recommend to use the Vortex projector which will optimize the wrap-around and penetrating effect of the paint on the recessed areas. For flat shaped parts, the flat spray aircap will give the best results.
At the end of the day, leave the aircap and nozzle - only those 2 parts - in the water until the next use.
The Nanogun airspray H20 version does not requires ATEX compliance and can be use in job coaters activities as long as the ventilation is correctly renewed.
"Tips and Tricks": The use of our gun cover will pertfectly protect your gun. When you flush, we recommend you place your gun on the side wall of the paint container to prevent any splashing.
Specially dedicated to the Nanogun Airspray electrostatic spray gun : user-friendly, it yields a high voltage/current constant curve. The control panel allows to control the atomization air, the pump pressure (air for product pressure) and flow rate adjustment.
Tips and Tricks: for a safe and quick start-up, always check that the Isocube is properly grounded as the state of the art. Then check your paint viscosity (up to 50s CA4) , then, stirr well the paint before priming. You need to start the pump smoothly to prevent air entraped in the fluid circuit.
You will need to select the right length of hoses between the paint pump and the spray gun depending on your installation and your spray booth location .
"Tips and Tricks": For operator safety , only use our genuine hoses (7,5 and 15 m) and in any case and never make any hose extension.
You should select the size of your pressure pot according to your application and paint. Example, for touch-up works, we recommend you use the 2 liters capacity tank. For water-based paints, we recommend to use a stainless steel tank fitted with an agitator and a bottom outlet.
"Tips and Tricks": For large capacity pressure pots, you can fit several propellers on the agitator rod.
PMP150 is our easiest pumping solution. It is a diaphragm pump (for application requiring a 1:1 ratio) and can be used with adhesive, medium viscosity or harsh coating.
"Tips and Tricks": You need to operate this pump with a clean air - without any condensation - it is why we recommend the use of an epurator on the air circuit.
During the flushing operation, always open wide the fluid regulator for a better cleaning of the fluid passage recessed areas. The suction rod need also to remain in the solvent.
This cup lub pump range represents an economical production/price ratio. Those pumps are dedicated for solvant and water-based paints.
Our SAMES KREMLIN pump range features fluid section stainless steel This pump is not recommended for moisture-sensitive materials. In case of multiple color changes, we recommend to use the smallest hydraulic section which matches your need to save paint and solvents..
"Tips and Tricks": In case of very viscous materials, this pump type can be fed under pressure.
